Pioneer GM-D9500F Owner's Manual - Page 11

Connecting the units Section 03 English Note ! If speaker wires with an RCA pin cord from a headunit are connected to this amplifier, the amplifier will automatically turn on when the headunit is turned on. When the headunit is turned off, the amplifier turns off automatically. This function may not work with some headunits. In such cases, please use a system remote control wire (sold separately). If multiple amplifiers are to be connected together synchronously, connect the head unit and all amplifiers via the system remote control wire. ! Connect the system remote control wire when you wish to only turn on the car stereo, not the amplifier. ! This amplifier automatically selects an input signal mode between the RCA level and the speaker level by detecting an input signal. 1 Positive (+) terminal 2 Engine compartment 3 Vehicle interior 4 Fuse (30 A) × 2 5 Insert the O-ring rubber grommet into the vehicle body. 6 Drill a 14 mm hole into the vehicle body (1/2 in.) . 2 Twist the battery wire, ground wire and system remote control wire. Twist Connecting the power terminal ! The use of a special red battery and ground wire RD-223, available separately, is recommended. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. 3 Attach lugs to wire ends. Lugs not supplied. Use pliers, etc., to crimp lugs to wires. WARNING If the battery wire is not securely fixed to the terminal using the terminal screws, there is a risk of overheating, malfunction and injury, including minor burns. 1 Route battery wire from engine compartment to the vehicle interior. After completing all other amplifier connections, finally connect the battery wire terminal of the amplifier to the positive (+) battery terminal. 1 Lug 2 Battery wire 3 Ground wire 4 Connect the wires to the terminal. Fix the wires securely with the terminal screws. En 11