Pioneer PDP-4271HD Owner's Manual - Page 28
PDP-4272HD/PDP-4271HD/PDP-4270HD
View all Pioneer PDP-4271HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
05 Preparation PDP-4272HD/PDP-4271HD/PDP-4270HD CAUTION The weight of a 42 inch Plasma Display is about 29 kg (64 lbs.), it has no depth, and is unstable. Therefore, at least two people must assemble and install it. Detaching the stand 1 Loosen and remove the two installation bolts ➀ using the enclosed hexagonal wrench. Attaching the stand again 1 Fit the stand's support columns to the bottom of the Plasma Display as indicated by arrows, then slowly insert them vertically. • Be extremely careful not to insert the support columns of the stand into any part of the Plasma Display other than the stand insertion slots. Doing so might damage the Plasma Display panel or its ports or result in the warping of the stand. Installation bolts ➀ (M8 x 30 mm: silver) 2 Loosen and remove the two installation bolts ➁ using the enclosed hexagonal wrench. Line up the column supports with the bottom of the Plasma Display as indicated in the accompanying diagram. 2 Attach the Plasma Display at the points indicated by the arrows and tighten the installation bolts ➁ firmly using the enclosed hexagonal wrench. Installation bolts ➁ (M8 x 60 mm: silver) 3 Remove the Plasma Display from the stand. Installation bolts ➁ (M8 x 60 mm: silver) 3 Tighten the installation bolts ➀ firmly using the enclosed hexagonal wrench. • Make sure to keep the installation bolts ➀ and ➁ that have been removed as they are re-used when attaching the stand to the Plasma Display. Installation bolts ➀ (M8 x 30 mm: silver) NOTE NOTE • Be sure to install it on a flat, stable location. 28 • Be sure to install it on a flat, stable location. • Insert the screws in the holes vertically and do not tighten them with more force than necessary. En