Pioneer PDP-433CMX Operating Instructions - Page 21

English Français Installation and Connections Control Cord Connection When control cord connections are made, remote control operation of connected PIONEER components that bear the Î logo mark is done through the remote sensor on this unit. When the connection is made to the CONTROL IN jack on another unit, the remote sensor of that component will no longer receive signals. Point the remote control unit of the connected component at the remote control sensor on this unit to control. Notes ÷ Make sure the power is turned off when making connections. ÷ Please complete all component connections before making control cord connections. Main unit CONTROL IN OUT CONTROL IN OUT CONTROL IN OUT CONTROL IN OUT Power Cord Connection Connect the power cord after all component connections have been completed. 1 2 1 Connect the power cord to this unit. 2 Plug the power cord into a power outlet. CAUTION ÷ Use only the power cord provided. ÷ Do not use a power supply voltage other than that indicated (AC 100 - 120 V, 50/60 Hz) as this may cause fire or electric shock. ÷ For the plasma display, a three-core power cord with a ground terminal is used for efficiency protection. Always be sure to connect the power cord to a three-pronged grounded outlet and make sure that the cord is properly grounded. If you use a power source converter plug, use an outlet with a ground terminal and screw down the ground line. The control cables (not supplied) are monaural cables with mini plugs (no resistance). Installation and Connections 15 En