Pioneer SC-75 Owner's Manual - Page 43
Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver
View all Pioneer SC-75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
03 Connecting your equipment Connecting an IR receiver If you keep your stereo components in a closed cabinet or shelving unit, or you wish to use the sub zone remote control in another zone, you can use an optional IR receiver (such as a Niles or Xantech unit) to control your system instead of the remote sensor on the front panel of this receiver. ! Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote sensor window. ! Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your com- ponent to check for IR compatibility. ! If using two remote controls (at the same time), the IR receiver's remote sensor takes priority over the remote sensor on the front panel. 1 Connect the IR receiver sensor to the IR IN jack on the rear of this receiver. Closet or shelving unit Non-Pioneer component IR IN IR OUT IN 1 IN 2 Switching components on and off using the 12 volt trigger You can connect components in your system (such as a screen or projector) to this receiver so that they switch on or off using 12 volt triggers when you select an input function. However, you must specify which input functions switch on the trigger using the The Input Setup menu on page 47. Note that this will only work with components that have a standby mode. 12V TRIGGER INPUT 12VTRIGGER 1 2 (OUTPUT 12 V TOTAL 150 mA MAX) 12VTRIGGER 1 2 (OUTPUT 12 V TOTAL 150 mA MAX) % Connect the 12 V TRIGGER jack of this receiver to the 12 V trigger of another component. Use a cable with a mono mini-plug on each end for the connection. After you've specified the input functions that will switch on the trigger, you'll be able to switch the component on or off just by pressing the input function(s) you've set on page 47. IR receiver IR OUT IN 1 IN 2 2 Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver to link it to the IR receiver. Please see the manual supplied with your IR receiver for the type of cable necessary for the connection. Note ! It is also possible to have the component switch not when the input function is switched, but when HDMI OUT is switched. For details, see HDMI Setup on page 70. 43