Pioneer SX-10AE Instruction Manual English - Page 8
Step1: Connect the Speakers
View all Pioneer SX-10AE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
> Before Start > Part Names > Install > Playback Step1: Install Connect the Speakers 5/8˝ (15 mm) a a * Setup | Others You can connect two systems, Speaker A and Speaker B, as the Speaker System. When connecting only one set, connect to the SPEAKERS A terminals. With one set, use speakers with 4 ≠ to 16 ≠ impedance. Note that when connecting to both SPEAKERS A and B terminals, connect speakers with 8 ≠ to 16 ≠ impedance to both A and B. Connect the speaker cable so the wires do not protrude from the speaker jacks. If the exposed wires of the speakers touch the rear panel or the + and - wires touch each other, the protection circuit will be activated. Setup 0 When connected as a Speaker B System, you can output the same audio as Speaker A System by switching with A/B/A+B. Press SPEAKER A/B on the main unit to switch. The selection changes in the order SPEAKER A, SPEAKER B, SPEAKER A+B, Off with each press. 0 If any of the connected speakers have an impedance of 4 ≠ or more to less than 6 ≠, or when a Speaker B system is to be used, press SETUP (P7) on the remote controller, and set "SP Impedance" to "4 ohm". (*)You can also connect a powered subwoofer to the PRE OUT SUBWOOFER jack to boost bass playback even more. Use a subwoofer cable for connection. a Speaker Cable 8 Right Left Speaker A Right Left Speaker B