Pioneer VREC-DZ700DC Owners Manual - Page 13

English Before Installing the Product WARNING • Never install on the cover of an airbag or at locations that might obstruct the deployment of the airbag. Doing so might prevent the airbag from being deployed normally, cause the product to fly out due to airbag deployment, and cause accident and injury. • First check with the vehicle manufacturer for precautions related to the installation work when installing the product in a vehicle equipped with airbags. Otherwise there is a risk of airbag malfunction. CAUTION • Always use the included parts as specified. There is a risk of product failure if other parts are used. • Install this product in a location where it will not hinder vehicle equipment and the ability to drive the vehicle. Installation Precautions • The main unit and 2nd camera are for installation to the inside of the front and rear windows only. Do not install it anywhere else inside or outside of the vehicle. • When installing main unit to the inside of the front windshield, be sure to install them to the specified positions of the front windshield and within the specified dimensions. • When installing the 2nd camera to the inside of the rear window, pay attention to the following points. -- Avoid installing the 2nd camera on heating wires on windshields. -- If the vehicle is provided with a rear wiper, install so that it is within the wiping range of the wiper. -- Install the 2nd camera as far as possible from the high mount stop lamp. • Depending on the vehicle, installation at the specified location and within the specified dimensions may not be possible. For details, consult with your dealer. • Do not cover this product and 2nd camera or get the lens dirty. • Do not place reflective objects near the lens. • Take care when handling this product and 2nd camera so that they do not drop and you do not touch the lens. • Recording quality may be affected if the front windshield of the vehicle is coated or has been specially treated. • This product may not be able to receive GPS signals if the front windshield of the vehicle has been specially treated. Check the GPS reception status indicator displayed on the screen of this product. If a GPS signal cannot be received, this product cannot be installed in this vehicle. → "Using this product" - "Status Display" • Choose a working location free from dust and debris in the air. • When the temperature is low or there is condensation on the glass, turn on the heater and defroster to warm up the window in order to prevent poor adhesion of the double-sided tape. Double-sided tape cannot be re-applied once it is peeled off as peeling off weakens its adhesive strength. Be sure to temporarily fasten this product and 2nd camera and sufficiently consider routing of cables before applying double-sided tape. − 13 −