Pioneer XW-NAC1-K Operating Instructions - Page 13

iPod/iPhone playback 03 English Français Español HI-LITE Scan Each track is played back for a few seconds at a certain time from the track beginning, thus allowing desired tracks to be found quickly. 1 Connect two iPod/iPhone units to the iPod/iPhone connector ports (iPod a, iPod b), then press iPod a or iPod b. 2 Press MENU to access the iPod/iPhone menu. 3 Select the track area that you want to play back, then press ENTER. 4 Press HI-LITE. HI-LITE scan function will begin from the first track on the selected iPod/iPhone. If playback was already underway, the HI-LITE scan will begin from the currently playing track. After a track is played for a few seconds, the next track will be found and a certain time1 from the track beginning will be played for a few seconds. When two iPod/iPhone units are connected simultaneously, the first track on the alternate iPod/iPhone will be found and a certain time from the track beginning will be played for a few seconds. Thereafter, the same process will be repeated until all tracks have been found and played for a few seconds each. • To cancel the HI-LITE Scan operation, press HI-LITE once more. • The HI-LITE Scan mode will also be canceled if the function is switched to any another input (including iPod a or iPod b). • Check whether the iPod/iPhone was supported by this unit. • Reconnect the iPod/iPhone to the unit. If this doesn't seem to work, try resetting your iPod/iPhone. • Update the iPod/iPhone software to the latest version. If the iPod/iPhone cannot be operated, check the following items: • Is the iPod/iPhone connected correctly? Reconnect the iPod/iPhone to the unit. • Is the iPod/iPhone experiencing a hangup? Try resetting the iPod/iPhone, and reconnect it to the unit. Tip • iPod/iPhone recharging occurs whenever an iPod/iPhone is connected to this unit. (This function is supported in standby mode as well.) • If an iPod/iPhone unit is connected to this unit when it is already in play mode, turning the unit's power ON or switching input to iPod will cause iPod/iPhone playback to automatically begin. • When this unit's power is turned ON with another function is selected, even if an iPod/iPhone in play mode is connected, playback will not automatically begin. • When input is switched from iPod to another function, the iPod/iPhone's power will be turned OFF automatically. • If the unit is set to standby when an iPod/ iPhone is connected, the iPod/iPhone's power will be turned OFF automatically. Important If the power indicator and iPod/iPhone indicator flash simultaneously, a connection fault is indicated. Perform the following troubleshooting checks: Note 1 If a track's total length is too short, the track will be played back from the track beginning for a few seconds. 13 En