Pioneer XW-NAC1-K Operating Instructions - Page 7
English, Français, Español
View all Pioneer XW-NAC1-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Before you start 01 English Français Español • Remove the battery if the unit isn't going to be used for a month or more. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. • WARNING Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. "Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/ perchlorate. (Applicable to California, U.S.A.) " Using the remote control The remote has a range of about 7 m (23 ft.) at an angle of about 30º from the remote sensor. Installing the unit • When installing this unit, make sure to put it on a level and stable surface. Don't install it on the following places: - on a color TV (the screen may distort) - near a cassette deck (or close to a device that gives off a magnetic field). This may interfere with the sound. - in direct sunlight - in damp or wet areas - in extremely hot or cold areas - in places where there is vibration or other movement - in places that are very dusty - in places that have hot fumes or oils (such as a kitchen) Plugging in After you've finished making all connections, plug the unit into an AC outlet. AC IN 30° 30° 7 m (23 ft.) Keep in mind the following when using the remote control: • Make sure that there are no obstacles between the remote and the remote sensor on the unit. • Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor. • Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit. • Replace the batteries when you notice a fall off in the operating range of the remote. 1 Plug the supplied power cord into the AC IN socket on the back of the unit. 2 Plug the other end into a power outlet. Important • Before making or changing any connections, switch off the power and disconnect the power cord from the AC outlet. 7 En