Pioneer XW-NAC1-K Operating Instructions - Page 6
Before you start
View all Pioneer XW-NAC1-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
01 Before you start Chapter 1: Before you start What's in the box Please confirm that the following accessories are in the box when you open it. • Remote control • Lithium battery (CR2025) (The lithium battery has been factory installed in the remote control unit.) • Power cord • Operating instructions (This document) Replace the battery When replacing the battery, use a commercially available Lithium CR2025 battery. 1 1 3 2 Before using the remote control 1 While pushing the release tab, pull out the battery casing. 2 Remove the battery from the casing. 3 Place a new battery in the casing. Make sure the side of the battery is facing up when you place it in the space provided. The battery supplied with this unit is stored in the battery casing. • Remove the protective seal from the battery casing. When you notice a decrease in the operating range, replace the battery (see below). 6 En Caution When using lithium batteries, please observe the following: • There is danger of explosion if the battery is incorrectly replaced. Make sure to replace only with the same or equivalent type recommended by the manufacturer. • Dispose of used battery cells immediately after replacement. Keep away from children. • Store lithium batteries, out of the reach of children and infants. If accidentally swallowed, contact a doctor immediately. • Lithium batteries may present a fire or chemical burn hazard if misused. Do not disassemble, heat above 100 °C, or incinerate.