Polk Audio Atrium Sat300 User Guide - Page 10
Instructions, Caution: Secure mounting, required, prevent, personal injury, damage, speaker.
![]() |
View all Polk Audio Atrium Sat300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
I Instructions: Note: A pendant cable (not included) is required to hang the Atrium SAT300 loudspeaker from a ceiling or overhead beam. Use a cable that meets or exceeds the safety and/or building codes applicable to the mounting situation. The speaker weighs 3.5 lbs. on its own. 1. Determine how far down from your ceiling or beam you want your loudspeaker to hang. 4. Expose the loudspeaker spade terminals on the back of the cabinet by removing the knob, clamp and bracket. 2. Secure the pendant cable to the ceiling or beam and run loudspeaker wire along the pendant cable. 3. Attach the supplied faston connectors to the loudspeaker wires. · (Large ="+", Small ="-") 5. Disconnect the existing loudspeaker wire from the spade terminals using needle-nose pliers and remove the bracket assembly. 6. Thread the new speaker wire through the wire hole in the pendant cap and connect the wires to the loudspeaker spade terminals, observing correct polarity. 7. Attach the pendant cap to the speaker using the eyebolt, lock washer and nut. 8. Secure the pendant ,cable to the eyebolt. Caution: Secure mounting is required to prevent personal injury or damage to the speaker. Customer Service Hours of Operation: Monday-Friday 9AM-6PM EST [email protected]
![](/manual_guide/products/polk-audio-atrium-sat300-user-guide-ef166f1/10.png)