ProForm 12.0tt Treadmill English Manual - Page 16

Damaged When You Turn On The, You Do Not Connect The Connectors

Get ProForm 12.0tt Treadmill PDF manuals and user guides View all ProForm 12.0tt Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

14. Insert the Upright Wire (81) and the indicated wire (J) through the two indicated looped ties (L) 14 on the console assembly (K). See the inset drawing. Connect the Upright Wire (81) and the other wire (J) to the console wires (M). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Insert all excess wires into the console assembly (K). Then, pull the two ties (L) tight against the wires and cut off the ends of the ties. 15. Insert the wire (J) on the left side through the two indicated looped ties (L) on the console assem- 15 bly (K). Then, connect the wire to the wire (not shown) from the console assembly. Insert all excess wires into the console assembly (K). Then, pull the two ties (L) tight against the wire and cut off the ends of the ties. K L Console 81 Wire J M 81 J K L J 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
16
14. Insert the Upright Wire (81) and the indicated
wire (J) through the two indicated looped ties (L)
on the console assembly (K).
See the inset drawing.
Connect the Upright
Wire (81) and the other wire (J) to the con-
sole wires (M).
The connectors should slide
together easily and snap into place.
If they
do not, turn one connector and try again.
IF
YOU DO NOT CONNECT THE CONNECTORS
PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE
POWER.
Insert all excess wires into the console assembly
(K). Then, pull the two ties (L) tight against the
wires and cut off the ends of the ties.
15. Insert the wire (J) on the left side through the two
indicated looped ties (L) on the console assem-
bly (K).
Then, connect the wire to the wire (not
shown) from the console assembly.
Insert all excess wires into the console assembly
(K). Then, pull the two ties (L) tight against the
wire and cut off the ends of the ties.
14
15
K
K
81
M
81
L
J
J
L
J
Console
Wire