ProForm 295 Cse Instruction Manual - Page 14

18. Lift the latch (E) on the underside of the Right Pedal Arm (14), and set the Right Pedal Arm on 18 the right Crank Bushing Sleeve (43). Release the lever, and make sure that the Right Pedal Arm (14) is securely connected to the Crank Bushing Sleeve (43). Connect the Left Pedal Arm (not shown) in the same way. See step 6. Tighten the M8 x 69mm Bolt (80) and the two M8 x 23mm Screws (84). 14 E 43 19. See the upper and lower drawings. Plug the Power Adapter (60) into the receptacle (F) inside the indicated battery compartment on the Console (5), and route the power adapter through the notch (G) in the battery cover. Note: To plug the Power Adapter (60) into an outlet, see HOW TO PLUG IN THE POWER ADAPTER on page 15. See the lower drawing. The Console (5) can also be operated with four D batteries (not included); alkaline batteries are recommended. Do not use old and new batteries together or alkaline, standard, and rechargeable batteries together. Remove the screws (H), remove the battery covers (I) from the back of the Console (5), insert batteries into the battery compartments, and then reattach the battery covers. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. 19 5 5 F I G 60 H F 20. Make sure that all parts of the elliptical are properly tightened. Extra parts may be included. To protect the floor or carpet from damage, place a mat under the elliptical. 14