ProForm 475 Audio Series Treadmill Uk Manual - Page 13

17. Carefully raise the Uprights (only one is shown). 17 Attach the Latch Housing (30) to the Left Upright (31) with two 3/4" Screws (2). Make sure that the large hole in the Latch Housing is on the 30 side shown. Do not overtighten the Screws. If the pin is not preassembled in the Latch Knob Housing (30), remove the knob from the pin. Make sure that the collar and the spring are on 31 the pin as shown. Insert the pin into the Latch 2 Housing, and tighten the knob back onto the pin. Spring Collar Pin 18. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill. If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated Screw (2) and the Access Door (35) from the left side of the Console (25). 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console (25). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (35) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (35) with the Screw (2). Discard the other wires included with the receiver. Wire 25 Small Screws 35 A Small 2 Cylinder 13