ProForm 480 Spacesaver Elliptical Uk Manual - Page 8

5. Tip: Avoid pinching the Wire Harness (64). Attach the Upright (10) to the Frame (1) with four M8 x 19mm Patch Screws (86) and four M8 Split Washers (97). 5 64 86 97 97 1 Avoid pinching the Wire Harness (64) 10 97 97 86 6. Identify the Right Pulse Bar (39), which is marked with a "Right" sticker. Orient the Right Pulse Bar so that the hexagonal holes are in the indicated location. Have another person hold the Right Pulse Bar (39) near the Upright (10). See the inset drawing. Locate the wire tie in the Upright. Tie the lower end of the wire tie to the right Pulse Wire (63). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Avoid pinching the wires. Slide the Right Pulse Bar (39) onto the right side of the Upright (10). Attach the Right Pulse Bar with two M8 x 36mm Button Bolts (77) and two M8 Locknuts (94). Make sure that the Locknuts are in the hexagonal holes. Repeat this step for the Left Pulse Bar (19). 6 19 Wire Tie 77 64 10 63 39 Wire Tie 63 94 Hexagonal Holes Avoid pinching the wires 8