ProForm 700tr Elliptical Uk Manual - Page 9
Attach the Left Handlebar Cover 109 to the Console
View all ProForm 700tr Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
11. Attach the Left Handlebar Cover (109) to the Console (5) with three M4 x 16mm Screws (116). Attach the 11 Right Handlebar Cover (110) in the same way. 5 See assembly step 9. Tighten the eight M6 x 16mm Tapered Button Screws (107). 110 109 116 12. Plug one end of the Power Supply (96) into the jack at the rear of the elliptical crosstrainer. Using the included adaptor (not shown), plug the other end of the Power Supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 116 12 Note: The Console (5) can be operated with batteries instead of the Power Supply (96) if desired. To install batteries, follow the instructions below. See the inset drawing. Press the indicated tab on the battery drawer and pull the battery drawer down. Press four "D" batteries into the battery clips; make sure that the batteries are oriented as shown by the markings inside of the battery clips. Then, close the battery drawer. Note: Alkaline batteries are recommended. Battery Drawer Tab Power Jack 96 5 Batteries 13. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. The elliptical crosstrainer is now fully assembled. If you have purchased the optional chest pulse sensor (see page 20), go to page 21. 9