ProForm 738 Bench User Manual - Page 6
the Nylon Locknut.
View all ProForm 738 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
6. Refer to the inset drawing. Insert the Weight Tube (42) into the indicated hole in the Leg Lever (21). Attach the Weight Tube with an M8 x 60mm Bolt (48), two 8mm Washers (46), the 13.5mm Spacer (47), and an M8 Nylon Locknut (45). Press two 50mm Square Endcaps (24) into the Leg Lever. Refer to the inset drawing. Press a 25.4mm Endcap (22) into the indicated end of the Weight Tube. Press the Leg Lever Bumper (23) into the other end of the Weight Tube. Note: The above parts may have been pre-assembled at the factory. Lubricate the M12 x 95mm Bolt (32). Attach the Leg Lever (21) to the Frame (4) with the Bolt and the M12 Nylon Locknut (36). Do not overtighten the Nylon Locknut. 7. Insert 25.4mm Square Endcaps (18) into the ends of both Backrest Rails (10). Attach the Backrest Rails (10) to the Backrest (8) with four M6 x 40mm Bolts (27) and four M6 Washers (44). Do not tighten the Bolts yet. Make sure that the Backrest Rails are turned as shown. Attach the Backrest Rails (10) to the tube on the Frame (4) with the M10 x 190mm Bolt (30), two 10mm Washers (34), and an M10 Nylon Locknut (35). Do not overtighten the Nylon Locknut. Tighten the four M6 x 40mm Bolts (27). 6 24 21 46 45 23 46 48 47 22 4 24 42 36 21 32 Lubricate 7 8 18 10 44 27 44 27 35 34 34 4 30 18 8. Attach the Seat (7) to the Frame (4) with two M6 x 15mm Screws (29), an M6 x 65mm Bolt (41), 8 and three M6 Washers (44) as shown. 7 4 44 41 29 6