ProForm 800 Tr Intrac Erg Bike Uk Manual - Page 6
Wire Harnesses 42, 43. Move the Upright up
View all ProForm 800 Tr Intrac Erg Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2. Whilst another person lifts the rear of the Frame (1), 2 attach the Rear Stabiliser (16) to the Frame with four M8 x 70mm Button Screws (68). 1 16 3. Whilst another person holds the Upright (2) in the posi- 3 tion shown, connect the Upper Wire Harness (42) to the Lower Wire Harness (43). Gently pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses. Turn the indicated Adjustment Knob (20) counterclockwise two or three turns to loosen it. Next, pull the Knob, insert the Upright (2) into the Frame (1), and then release the Knob. Be careful to avoid pinching the Wire Harnesses (42, 43). Move the Upright up and down slightly until the pin on the Knob snaps into one of the holes in the Upright. Then, turn the Knob clockwise until it is tight. 68 Make sure the wire harnesses do not get pinched and damaged during 2 this step. 42 1 20 43 4. Loosen the eight indicated screws (A) in the Handlebar (3). Attach the Handlebar (3) to the Upright (2) with eight M6 x 16mm Tapered Button Screws (59). Do not tighten the Tapered Button Screws yet. Retighten the eight screws (A) in the Handlebar (3). 4 59 59 3 A A 2 6