ProForm 800 Tr Intrac Erg Bike Uk Manual - Page 7

5. See step 6. Remove the three indicated M4 x 12mm Screws (41) and the Left and Right Handlebar Covers (6,5) from the Console (4). Whilst another person holds the Console (4) in the position shown, connect the wire harnesses on the Console to the Upper Wire Harness (42) and the Pulse Wire Harness (81). Insert the excess wire harness down into the Upright (2). Attach the Console (4) to the Upright (2) with four M4 x 12mm Screws (41). Be careful to avoid pinching the wire harnesses. 5 41 4 42 2 81 Wire Harnesses 6. Attach the Left Handlebar Cover (6) to the Console (4) with three M4 x 16mm Screws (57). Attach the Right Handlebar Cover (5) in the same way. Attach the CD Holder (80) to the Console (4) with two M4 x 12mm Screws (41) as shown. See assembly step 4. Tighten the eight M6 x 16mm Tapered Button Screws (59). 7. Turn the indicated Adjustment Knob (20) counterclockwise two or three turns to loosen it. Next, pull the Knob, remove the packing tube from the Frame (1), and insert the Seat Post (8) into the Frame. Release the Knob, and move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwise until it is tight. Slide the Seat Carriage (11) onto the Seat Bracket (7), and then tighten the Seat Knob (10) into the right side of the Seat Carriage. Tighten the M6 x 8mm Zinc Button Screw (71) into the Seat Bracket behind the Seat Carriage. Loosen the two nuts (not shown) on the clamp beneath the Seat (9). Slide the clamp fully onto the Seat Carriage (11). Tilt the Seat to the desired angle, and then retighten the nuts on the clamp. 6 80 41 57 6 7 9 Nut 71 4 5 Nut 10 8 7 11 20 Packing Tube 1 7