ProForm R950 Space Saver English Manual - Page 8

MAINTENANCE AND STORAGE Inspect and tighten all parts of the R-950 regularly. Clean the R-950 periodically with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight. 1. Hold the Handlebar (4) firmly and pivot it back and down until the Wheel (26) hits the stop tab. Next, lift the Seat (7) slightly and continue to pivot the Handlebar down until the R-950 is in the position shown in drawing 1a. Fold down the Console (13). HOW TO LUBRICATE THE R-950 Every three months, a small amount of light multi- purpose oil should be applied to the R-950. Apply a few drops of Apply Oil oil between the dome caps and the frame in the locations shown at the right. Be sure to apply oil to both sides of the R-950. CONSOLE TROUBLE-SHOOTING 1 Stop Tab 1a 13 4 7 26 If the console does not operate properly, the batteries should be replaced. See assembly step 2 on page 4 for installation instructions. If the console does not dis- play correct feedback, the position of the 2. If desired, the R-950 can be stored in a 2 Tab vertical position. 4 1 Reed Switch (33) should be 35 Fold the R-950 as described above. adjusted. 33 Next, firmly hold Loosen, but do the Handlebar (4) not remove, with one hand, and the two indi- hold the rear tube cated #8 x 1/2Ó of the Frame (1) Screws (35). Slide the Screws slightly forward or with the other backward in the slots, making sure to keep the upper hand. Raise the R- Screw directly above the lower Screw. Make sure 950 to the position that the lever on the Reed Switch is behind the shown at the right.