ProForm Ze5 Elliptical English Manual - Page 11

10. Identify the Right Handlebar (59), which is marked with a "Right" sticker, and orient it as shown. Have a second person hold the Right Handlebar (59) near the right side of the Upright (2). Locate the wire tie in the Upright. Tie the lower end of the wire tie to the right Pulse Wire (28). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Avoid pinching the Pulse Wire (28). Attach the Right Handlebar (59) to the Upright (2) with two M6 x 38mm Bolts (108) and two M6 Locknuts (74). Make sure that the Locknuts are in the hexagonal holes. Repeat this step to attach the Left Handlebar (39). 10 39 Avoid pinching the Pulse Wires (28) 28 Wire Tie 2 28 74 Hexagonal Holes 108 59 11. The Console (4) can use four D batteries (not included); alkaline batteries are recommended. 11 IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic compo- nents. Remove the screw, remove the battery cover, insert the batteries into the battery com- partments, and reattach the battery cover. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. To purchase an optional AC adapter, contact the store where you purchased this product or call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied AC adapter. Plug one end of the AC adapter into the jack on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. Screw Battery Cover Batteries 4 11