ProForm Ze5 Elliptical English Manual - Page 24
How To Adjust The Reed Switch
View all ProForm Ze5 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the right pedal arm and the right pedal disc (see the instructions below). See EXPLODED DRAWING B on page 30. Remove the M8 x 18mm 26 Patch Screws (80), the Pedal Arm Caps (30), and the M8 Washers (33), and then remove the Right Pedal 49 Arm (49). Using a flat screwdriver, release the tabs on the right Pedal Disc (26) and remove the Pedal Disc. Locate the Reed Switch (58). Loosen, but do not remove, the M4 x 16mm Screw (92). 41 58 110 92 Next, rotate the Pulley (110) until a Magnet (41) is aligned with the Reed Switch (58). Slide the Reed Switch slightly toward or away from the Magnet. Then, retighten the M4 x 16mm Screw (92). Rotate the Pulley (110) for a moment. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the right pedal disc and the right pedal arm. 24