ProForm Ze5 Elliptical English Manual - Page 23

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical exerciser Remove the four regularly. Replace any worn parts immediately. indicated M4 x 38mm Screws 45 To clean the elliptical exerciser, use a damp cloth and (86) from the a small amount of mild soap. IMPORTANT: To avoid Right Shield (45). damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 11 on page 11 for replacement instructions. If the handgrip pulse sensor does not function properly, see step 5 on page 18. HOW TO ADJUST THE DRIVE BELT Remove the M4 x 19mm Screws (25) from the Left Shield (44) and then remove the Left Shield. 86 44 If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. 25 To adjust the drive belt, you must remove the pedal arms, the pedal discs, and the left shield (see the instructions below). See EXPLODED DRAWING B on page 30. Remove the M8 x 18mm Patch Screws 26 (80), the Pedal Arm Caps (30), and the M8 Washers (33), and then remove the Left and Right Pedal Arms (14, 49). 14 49 Next, loosen the Pivot Screw (88). Then, tighten the Drive Belt Adjustment Screw (72) until the Drive Belt (46) is tight. When the Drive Belt (46) is tight, tighten the Pivot Screw (88). 46 88 72 Using a flat screwdriver, release the tabs on the right and left Pedal Discs (26) and remove the Pedal Discs. Then, reattach the left shield, the pedal discs, and the pedal arms. 23