Pyle PL1SN104 Instruction Manual - Page 13

Wheel Set Setting Connect the steering wheel control cable, and click the corresponding key to activate the function. After entering into the steering wheel control interface, then keep pressing the steering wheel "VOL+" button in your car, at the same time click " "in the interface, it will be selected, then it is finish this setting. Click other buttons according this method, the steering wheel function can be used. Troubleshooting Phenomenon Reasons Solutions Normal Fuse of machine power supply and auto Change for fuse of the vehicle battery is burnt, cottect types; Not operating Volatge of power supply is overloaded Adjust voltage; Automatic protection system avoids fault Reset the system by pressing the due to illegal operation Resetkey Check the wiring Wrong pin assignment ISO connector diagram Remote comtrol Battery is out of power; Change new battery; doesn' t work Battery is not placed correctly Reinstall battery Check the connecion; Increase the Disconnection; volume; Reconnection the silence Volume setting is low volume; wrong wire complied with the installation No or low sound connection of Silence; Loudspeaker fault; instruction; Change for a new Volume balance setting bias Earthing in loudspeaker; Adjust the volume loudspeaker connection balance setting to middle place; Keep insulation of loudspeaker connection Inferior quality of Inferior disc is used; Use genuine discs; sound; Distortion Loudspeaker does not match impedance Change a loudspeaker; of sound of the machine; Loudspeaker opens circuit. Check the connection of loudspeaker. Machine reset by itself when it is Connection of ACC and B+ is not correct. Check and reconnect ACC and B+ shut down www.PyleUSA.com 12