RCA L42FHD37 User Guide & Warranty - Page 6

Things to Consider Before You Connect - jack

Page 6 highlights

1 Connections and Setup Things to Consider Before You Connect Protect Against Power Surges • Connect all devices before you plug any power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch. • Turn off the TV and/or device(s) before you connect or disconnect any cables. • Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions. Instructions at the beginning of the User's Guide • Protect devices from overheating. • Don't block ventilation holes on any of the devices. Arrange the devices so that air can circulate freely. • Don't stack devices. • If you place devices in a stand, make sure you allow adequate ventilation. • If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't flow around other devices. Position Cables Properly to Avoid Audio Interference • Insert each cable firmly into the designated jack. • If you place devices above the TV, route all cables down one side of the back of the TV instead of straight down the middle. • If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables away from audio/video cables. Use Indirect Light Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting. Check Supplied Parts Check that the following parts were packed with your product. Note: If you need to replace your remote, call 1-800-338-0376. A shipping and handling fee, and the appropriate sales tax, will be charged upon ordering. Have your Visa, MasterCard, or Discover Card ready. REMOTE CONTROL PART # RC2254701/01 6 Chapter 1 Connections and Setup for models L42FHD38/ L46FHD38/L52FHD38/L40FHD380 for models L42FHD37/L46FHD37/L46FHD35 2 AA BATTERIES CABLE MANAGEMENT STRAP REMOTE CONTROL PART # RC2254702/01 POWER CORD Go to Page 7 to see the parts list for the table stand Graphics contained within this publication are presentation only.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

1
Connections and Setup
Note:
If you need
to replace your remote,
call
1-800-338-0376.
A shipping and
handling fee, and the
appropriate sales
tax, will be charged
upon ordering.
Have your Visa,
MasterCard, or Discover
Card ready.
6
Chapter 1
Connections and Setup
Graphics contained within this publication are presentation only.
Go to Page 7 to
see the parts list
for the table stand
Things to Consider Before You Connect
Protect Against Power Surges
Connect all devices before you plug any power cords into the wall outlet or power strip.
NEVER plug your TV into an outlet that is controlled by a wall switch.
Turn off the TV and/or device(s) before you connect or disconnect any cables.
Make sure all antennas and cables are properly grounded. Refer to the Important Safety
Instructions.
Instructions at the beginning of the User's Guide
Protect devices from overheating.
Don’t block ventilation holes on any of the devices. Arrange the devices so that air can
circulate freely.
Don’t stack devices.
If you place devices in a stand, make sure you allow adequate ventilation.
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air
from it won’t flow around other devices.
Position Cables Properly to Avoid Audio Interference
Insert each cable firmly into the designated jack.
If you place devices above the TV, route all cables down one side of the back of the TV
instead of straight down the middle.
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft
or indirect lighting.
Check Supplied Parts
Check that the following parts were packed with your product.
REMOTE CONTROL
PART # RC2254702/01
for models
L42FHD37/L46FHD37/L46FHD35
REMOTE CONTROL
PART # RC2254701/01
for models L42FHD38/
L46FHD38/L52FHD38/L40FHD380
POWER CORD
2 AA BATTERIES
CABLE MANAGE-
MENT STRAP