RCA MGWHTR Installation Manual - Page 2

WELCOME! The MyGuard Automatic Hot Water Heater Shut-Off System puts your mind at ease by protecting your home or business against water damage. Simply install the control unit and shut-off servo included in this package, and you're set to stop a disaster before it happens! This installation guide takes you through the steps to get set up. WHAT'S IN THE PACKAGE? Control unit with connection wire and sensors attached Automatic shut-off servo motor with connection wire attached Floor sensor (attached to control unit) (2) Servo pipe-mounting brackets Pressure-release output pipe sensor Hardware bag (1) Double-sided tape for control unit (2) Carriage Bolts, M5 x 50 x 0.8(mm) (attached to control unit) Power adapter for the control unit (2) Drywall screws with anchors (2) Carriage Bolts, M5 x 30 x 0.8(mm) (#6 x 1-1/4" Phillips pan-head) (2) Carriage Bolts, M5 x 24 x 0.8(mm) (2) Masonry screws (3/16" flat-head) (4) Wing nuts (2) Wire ties (100L) (4) Washers 3-outlet AC wall tap to provide an additional (3) Wire ties with double-sided tape (4) Spring Washers electrical outlet if needed (1) Large centering ring (20D) (1) Wire tie (163L) (1) Allen Wrench Mounting template for the control unit (1) Screw, M4 2