RCA MGWHTR Installation Manual - Page 5

2. ASSEMBLE THE SERVO RING & BRACKETS A. Install the brackets on the shut-off servo Find the following pieces in the hardware bag: 2 pipe-mounting brackets 2 wing nuts 2 short carriage bolts (M5 x 24) 2 flat washers 2 lock washers Find the bracket slots on the servo, shown here. The brackets should be mounted on the inside of these slots. Bracket slots Place one bracket over the inside of a servo slot. Insert a short carriage bolt through the bracket and servo slot. Place a flat washer, lock washer, and wing nut on the end of the bolt and tighten just enough so that the bracket stays in place. Then repeat with the other bracket. Short carriage bolt Wing nut Lock washer Flat washer 5