RCA MGWHTR Installation Manual - Page 8
Step 3
View all RCA MGWHTR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
STEP 3 (continued) Does the centering ring fit? If not, replace it! Nut Centering ring The servo's centering ring should fit over the shut-off valve's nut as shown here. If it doesn't, replace it with the larger centering ring provided in the hardware kit. 1. Use the provided Allen wrench to remove the small Allencap screw. 2. Remove the pre-installed (small) centering ring. 3. Install the larger centering ring. Then put the small washer and Allen-cap screw back in place. Tighten with the Allen wrench. Centering ring Small washer Small Allencap screw Allen wrench C. Close the brackets over the pipe Insert (1) M5 x 30 x 0.8(mm) carriage bolt through each bracket as shown here. (If these bolts are not long enough, use the M5 x 50 x 0.8(mm) ones instead.) Place (1) washer, (1) spring washer, and (1) wing nut over each carriage bolt and tighten just enough so that the servo stays mounted in place. 8