RCA RT2600 User Guide - Page 12
Test Tone / Channel balance, Connecting for Power, Using Headphones, Factory Setting - no sound
UPC - 044319201284
View all RCA RT2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Getting Started Test Tone / Channel balance Connecting for Power Channel balance Make sure you connect all your EN other electronic components and Your receiver is equipped with a test signal generator the speakers before plugging for balancing the channels. As the signal "travels" your receiver into the outlet. from channel to channel, adjust the level controls Plug the power cord in the wall until each channel plays at the same loudness level. outlet, matching the wide blade of the plug with the wide slot in the outlet. Be sure to insert the plug completely. Courtesy Dolby Laboratories Using Headphones To listen privately through your audio system, use the PHONES jack on the receiver. However, make sure you turn down the volume before you put on the headphones. Increase the volume to the desired level after headphones are in place. Level adjustment & surround channel level expectation Even though you adjust the surround channel to be as loud as the others on the test signal, you'll find that on actual program material the surround channel is usually much lower than the front. Don't be tempted to readjust the surround level; program producers use surround mostly for subtle atmospherics and ambience, and only rarely for special effects. A good surround mix doesn't call attention to itself; if it did, it would soon become distracting. Once headphones are connected, "HEADPHONE DOWN MIX 2 CHANNEL" will scroll on display. This feature automatically converts multi-channel speaker outputs to 2 channel stereo for your listening pleasure. Hearing Comfort & Well-Being • Do not play your headset at a high volume. Hearing experts advise against continuous extended play. • If you experience a ringing in your ears, reduce volume or discontinue use. NOTE The system is equipped with Dolby Digital, and manufactured under License from Dolby Laboratories. Dolby Digital Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic" and the double-D symbol are trademarks of Dolby Laboratories. Copyright 19921997 Dolby Laboratories, Inc. All Rights Reserved. Manufactured under License from Digital Theater Systems, Inc. US Pat. No. 5,451,942 and other world wide patents issued and pending. "DTS Digital Surround", are trademarks of Digital Theater Systems, Inc. copyright 1996 Digital Theater Systems, Inc. All Rights Reserved. Factory Setting The unit is preset to the following settings when you first power the receiver up right out of the box: Function = Tuner Volume setting = 45 Bass & treble = 0 dB Speaker settings: Center, rear, front = small Subwoofer = on EQ: FLAT NOTE Reset to Factory Settings: All preset radio stations and surround sound setting will be lost after factory setting is restored. You may restore factory setting with the following procedures: 1. Enter Standby mode 2. Press SURR. MODE key when holding SOURCE UP. 3. All preset stations will reset to FM87.5MHz and all receiver settings restore to default settings as described above. 9