Rane AC 22S Operation Manual - Page 5
Front Panel: Stereo 2-way Configuration - ac 22 manual
View all Rane AC 22S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
FRONT PANEL: STEREO 2-WAY CONFIGURATION 1 2-way operation: read the top row 234 5 6 1 234 5 6 CH 1 MASTER 46 2 8 0 10 LEVEL MASTER MONO SUB 46 2 8 0 10 LEVEL LOW MUTE LOW 46 2 8 MIN MAX DELAY LOW / HIGH 300 400 250 500 180 700 120 1.0k 90 1.5k 80 2.0k 75 3.0k 70 3.6k FREQUENCY LOW / MID HIGH 46 2 8 0 10 LEVEL INACTIVE STEREO MONO CH 2 MASTER 46 2 8 0 10 LEVEL INACTIVE LOW INACTIVE: MONO SUB 46 2 8 0 10 LEVEL MUTE MID 46 2 8 MIN MAX DELAY LOW / HIGH 300 400 250 500 180 700 120 1.0k 90 1.5k 80 2.0k 75 3.0k 70 3.6k FREQUENCY MID / HIGH HIGH 46 2 8 0 10 LEVEL HIGH 7 POWER AC 22S ACTIVE CROSSOVER Observe the labels screened above the controls for stereo operation. 1 CHANNEL 1 MASTER LEVEL controls the overall Level of Channel 1 without altering the relative settings of the HIGH and LOW Outputs. Unity gain for all LEVEL controls is at "7". 2 LOW LEVEL controls the Level of signal going to the LOW Output in this Channel. In the MONO SUB mode the Channel 1 LEVEL control sets the Level of the MONO SUB Output, Channel 2's LOW LEVEL control is inactive. 3 LOW MUTE: When pressed to the in position, all signal is removed from the LOW Output. This eases tune‑up procedures, as described on pages Manual-7 through 12. In the MONO SUB mode, the Channel 1 LOW MUTE switch mutes the MONO SUB Output, Channel 2's MUTE is inactive. 4 LOW DELAY control adds from 0 to 2 ms of time delay to the LOW OUT only. This allows a low frequency driver to be electronically phase‑aligned with a high frequency driver whose diaphragm is situated behind the low frequency diaphragm. Refer to Time Delay Adjustment on page Manual-6. NOTE: Both DELAY controls are inactive in the MONO SUB mode. 5 LOW / HIGH FREQUENCY: This 41‑detent selector determines the crossover frequency between the LOW and HIGH Outputs. The detents assure maximum accuracy and consistency between Channels. Refer to Selecting Crossover Frequencies on page Manual-6 to determine the proper setting for your particular system. 6 HIGH LEVEL controls the Level of signal going to the HIGH Output in this Channel. 7 CHANNEL 2 MASTER LEVEL controls the overall Level of Channel 2 without altering relative settings of the HIGH and LOW Outputs. 8 POWER indicator: If the power cable is plugged in and this yellow LED is lit, the unit ready to operate. Manual-2