Rane AC 22S Operation Manual - Page 6

REAR PANEL: STEREO 2-WAY CONFIGURATION 2-way operation: read the top row 1 Right Input 100-240 V COMMERCIAL AUDIO 50/60 Hz 7 WATTS EQUIPMENT 24TJ R AC 22S MADE IN U.S.A. RANE CORP. ACN 001 345 482 HIGH OUT LOW OUT HIGH OUT MONO SUB: OMIT MID OUT CH 2 IN OMIT MONO 7 3 High Amp 4 Low Amp 56 Left Input 2 STEREO 2-WAY HIGH OUT SUBWOOFER SWITCH MUST BE SET TO 2- CHANNEL FOR MONO 3-WAY PIN 2: POSITIVE PIN 3: NEGATIVE PIN 1: CHASSIS GND MODE SUBWOOFER 2-CHANNEL MONO SUB MONO 3-WAY OMIT MONO LOW OUT MONO SUB OUT LOW OUT CH 1 IN MONO 3-WAY IN This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3 High Amp 4 Low Amp Observe the labels screened above the Inputs and Outputs for stereo operation. 1 CHANNEL 1 INPUT connects to the left channel output of the mixer, equalizer or other source. 2 CHANNEL 2 INPUT connects to the right channel output of the mixer, equalizer or other source. 3 HIGH OUTPUTS: Connect Channel 1 HIGH OUT to the left channel input of the high frequency amp, and the Channel 2 HIGH OUT to the right channel input of the high frequency amp. 4 LOW OUTPUTS: Connect the Channel 1 LOW OUT to the left channel input of the low frequency amp and the Channel 2 LOW OUT to the right channel input of the low frequency amp. When the SUBWOOFER switch is set to MONO SUB, only use Channel 1 LOW OUT. Channel 2 LOW OUT is disconnected in MONO SUB mode. 5 SUBWOOFER switch disconnects the Output from Channel 2 LOW OUT and sums it with Channel 1 LOW OUT. The result is taken from the Channel 1 LOW OUT. 6 MODE switch: Set this switch for STEREO 2-WAY operation. 7 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connection! Manual-3