Rane AC 22S Operation Manual - Page 8

REAR PANEL: MONO 3-WAY CONFIGURATION 100-240 V COMMERCIAL AUDIO 50/60 Hz 7 WATTS EQUIPMENT 24TJ R AC 22S MADE IN U.S.A. RANE CORP. ACN 001 345 482 HIGH OUT HIGH OUT 2-way operation: 7 3 read the bottom row LOW OUT CH 2 IN MONO SUB: OMIT MID OUT OMIT MONO High Amp 4 Mid Amp 56 Input 1 STEREO 2-WAY HIGH OUT SUBWOOFER SWITCH MUST BE SET TO 2- CHANNEL FOR MONO 3-WAY PIN 2: POSITIVE PIN 3: NEGATIVE PIN 1: CHASSIS GND MODE SUBWOOFER 2-CHANNEL MONO SUB MONO 3-WAY OMIT MONO LOW OUT MONO SUB OUT LOW OUT CH 1 IN MONO 3-WAY IN This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Observe the labels below the Inputs and Outputs for Mono operation. 1 MONO (CHANNEL 1) INPUT: Plug the output of the mixer, equalizer or other signal source to this Input for mono operation. Do not use the Channel 2 INPUT for MONO 3-WAY operation. 4 Low Amp 2 HIGH OUTPUT: Connect this Output to the input of the high frequency amp. 3 MID OUTPUT: Connect this Output to the input of the mid frequency amp. 4 LOW OUTPUT: Connect this Output to the input of the low frequency amp. 5 MODE switch: Set this switch for MONO 3-WAY operation. 6 SUBWOOFER switch: Set this switch for 2-CHANNEL operation. 7 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connection! Manual-5