Reebok Trainer Rx 3.0 Cwl Bike English Manual - Page 11

Fcc Information

Get Reebok Trainer Rx 3.0 Cwl Bike PDF manuals and user guides View all Reebok Trainer Rx 3.0 Cwl Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

11. Plug the Game/Pulse Wire (58) into the Game/Pulse Receptacle (79) located in the Left 11 Shield (26). 58 79 26 12. Identify the Right Pedal (21), which is marked with an "R." 12 Using an adjustable wrench, firmly tighten the Right Pedal (21) clockwise into the Right Crank (23). Tighten the Left Pedal (not shown) counterclockwise into the Left Crank (not shown). To loosen the strap on the Right Pedal (21), press the indicated tab and pull the strap upward. To tighten the strap, simply pull the end of the strap downward. Adjust the strap on the Left Pedal (not shown) in the same way. 23 21 Strap Tab 13. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. WARNING: Per FCC rules, changes or modifications not expressly approved by ICON could void the user's authority to operate the equipment. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
11
12. Identify the Right Pedal (21), which is marked
with an “R.”
Using an adjustable wrench,
firmly tighten
the
Right Pedal (21)
clockwise
into the Right
Crank (23).
Tighten the Left Pedal (not shown)
counter-
clockwise
into the Left Crank (not shown).
To loosen the strap on the Right Pedal (21),
press the indicated tab and pull the strap
upward. To tighten the strap, simply pull the end
of the strap downward.
Adjust the strap on the
Left Pedal (not shown) in the same way.
12
13.
Make sure that all parts are properly tightened before you use the exercise bike.
Note: After assembly
is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.
21
23
Strap
Tab
11
58
26
79
11. Plug the Game/Pulse Wire (58) into the
Game/Pulse Receptacle (79) located in the Left
Shield (26).
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Per FCC rules, changes or modifications not expressly approved by ICON could void the
user's authority to operate the equipment.