Ricoh AP2610 Printer Configuration - Page 10

Directly to a Network Printer

Get Ricoh AP2610 - Aficio B/W Laser Printer PDF manuals and user guides
UPC - 026649007576
View all Ricoh AP2610 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Ricoh Printer Configuration on CUPS NOTE "root" login is required to perform the procedures described in the following sections. The screenshots below were taken from Linux PCs running Suse Professional V9.0 and Redhat 9.0. All methods discussed below except section 3.2.1 are applicable to all Linux versions . 3.2.1. Suse Yast2: 1. To display the Yast2 Printer Configuration window, type the following on the command line: # yast2 printer & . The Printer setup: Autodetected printers window shown in Figure 5, below, will open. Figure 5: Yast2 Printer Configuration Window From the Printers to configure list, select Other (not detected) and click on the Configure button to continue. 2. Select the backend or the method used to communicate with the printer from the Printer Type window. In the example shown in the following figure, Print Directly to a Network Printer is selected in the Select Your Printer Type list. Page 10 of 30 Visit our knowledgebase at: http://www.ricoh-usa.com/support/knowledgebase.asp Copyright 2003 Ricoh Corporation

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
Ricoh Printer Configuration on CUPS

NOTE
“
root
” login is required to perform the procedures described in the
following sections. The screenshots below were taken from Linux PCs
running Suse Professional
V9.0 and Redhat 9.0. All methods discussed
below except section 3.2.1 are applicable to all Linux versions .
3.2.1. Suse Yast2:
1.
To display the
Yast2 Printer Configuration
window, type the following on the
command line: #
yast2 printer & <enter>.
The
Printer setup: Autodetected
printers
window shown in Figure 5, below, will open.
Figure 5:
Yast2 Printer Configuration
Window
From the
Printers to configure
list, select
Other (not detected)
and click on the
Configure
button to continue.
2.
Select the backend or the method used to communicate with the printer from the
Printer Type
window. In the example shown in the following figure,
Print
Directly to a Network Printer
is selected in the
Select Your Printer Type
list.

Page 10 of 30
Visit our knowledgebase at:
Copyright 2003 Ricoh Corporation