Ricoh M 320F Setup Guide - Page 13

9. Check the result. Connection has succeeded: "Connected to access point." is displayed. Press [OK] to return to the screen displayed in Step 6, and then press the [Home] key to return to the initial screen. Connection has failed: "Failed to connect to access point." is displayed. Press [OK] to return to the screen displayed in Step 6. Check the configuration for the router (access point), and then try the connection again. 10. Press [Exit]. 11. Press [Back]. 12. Configuring the Wireless (Wi-Fi) settings is complete. To use the fax function, configure the settings on page 16 "3. FAX Settings (M 320FB/320F only)". ™ M 320 ● Make sure the Ethernet cable is not connected to the machine. ● In Steps 11 to 13, configure each setting within two minutes. The following item is necessary to set up a Wireless (Wi-Fi) connection. ● Router (access point) 1. Press the [ ] or [ ] key to select [Quit Setup], and then the [OK] key. Other Setup 22 Network Setup Quit Setup M0ESIC0011 2. Press the [OK] key. 3. Check that the router (access point) is working correctly. 4. Make sure the wireless LAN option is attached to the machine and the wireless (Wi-Fi) connection is enabled. For details, see page 6 "Attaching the wireless LAN option". 5. Press the [User Tools] key. DYG198 6. Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key. User Tools Wi-Fi Setup Wizard Network Settings 8 10 Print List/Report M0ESIC0020 7. Enter the administrator password. 8. Press the [ ] or [ ] key to select [Wireless (Wi-Fi)], and then press the [OK] key. Network Settings 2 5 Wired (Ethernet) Wireless (Wi-Fi) IPv4 Configuration M0ESIC0021 9. Press the [ ] or [ ] key to select [WPS], and then press the [OK] key. Wireless (Wi-Fi) 69 Current Connection Input SSID WPS ECB215 10. Press the [ ] or [ ] key to select [PBC], and then press the [OK] key. WPS Type 12 PBC PIN DSG092 11. Press [Yes]. PBC WPS PBC Connect ? Yes No DSG093 "Please push the [AP] within 2 minutes" appears, and the machine starts to connect in PBC method. 12. Press the WPS button on the router (access point) within two minutes. WPS CHV607 • For details about how to use the WPS button, refer to the manuals for the router (access point). 13. Check the result. Connection has succeeded: PBC Connection to AP has Succeeded EXIT DSG094 • Press [EXIT] to return to the screen displayed in Step 10, and then press the [User Tools] key to return to the initial screen. Connection has failed: PBC Connection to AP has Failed EXIT DSG095 • Press [EXIT] to return to the screen displayed in Step 10. Check the configuration for the router (access point), and then try the connection again. 14. Configuring the Wireless (Wi-Fi) settings is complete. To use the printer driver, install the printer driver according to the procedure on page 19 "4. Installing the Printer Driver". 11