Ridgid OL50145MWD Operation Manual - Page 12
Operation - pressure switch for
View all Ridgid OL50145MWD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION danger: Do not disassemble check valve, tank drain valves or safety relief valve with air in tank - bleed tanks. WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. FEMALE COUPLER HOSE ADAPTER END OMILILNUIBWE HPU1EMELPB-APORMRP2EOAWHULEC-OBOMMBPA RCOENSLUSBROICRACITOMN 4 6 DE ACIETE 80 2 40 120 0 bar 160 PRESSURE REGULATOR KNOB 4 6 TO 80 2 40 120 CLOSE 0 bar 160 Fig. 7 WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. WARNING: Do not attach any tools to the open end of the hose until start-up has been completed. ON OFF I O ON (i) ON (O) off ON/OFF SWITCH Fig. 8 caution: Do not use in an environment that is dusty or otherwise contaminated. Using the air compressor in this type of environment may cause damage to the unit. universal fitting on air compressor. Make sure to push the hose adapter end fully into the coupler until the sleeve springs forward to lock it in place. tURNING THE AIR COMPRESSOR On/OFF See Figure 8. APPLICATIONS Air compressors are utilized in a variety of air system applications. Match hoses, connectors, air tools, and accessories to the capabilities of the air compressor. You may use this product for the purposes listed below: Operating some air-powered tools Operating air accessories such as air nozzles and inflators n With the air compressor plugged in, pull the power switch to the ON position to power the compressor on. n To turn the air compressor off, push the power switch to the OFF position. NOTE: When the compressor is in the ON position, the air compressor will automatically turn back on when the designated tank air pressure drops below the preset pressure limit. It will also shut off again when the desired pressure is reached. attaching a hose See Figure 7. using the air compressor See Figures 9 - 10. n Make sure the air compressor is off and unplugged. n Rotate pressure regulator knob fully counterclockwise. n Attach hose with male connector to quick connect n Ensure power switch is in the OFF (O) position and air compressor is unplugged. n If not already installed, attach hose to compressor as previously instructed. 12