Rocketfish RF-RBREC User Manual (English) - Page 23

Note: HD streams are available if using the RF-RBKIT sender. If your system is in a maximum audio stream state, then the TX indicator will not light on the sender devices that have exceeded the maximum. To use those device's audio streams, you need to turn off one of your other senders. Maintaining your system Use a soft cloth dampened with a weak solution of mild detergent and water. Dry the device immediately afterwards with a clean cloth. Do not use abrasive cloth, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering. Cautions: Do not block the ventilation openings. If the power cord is damaged, it must be repaired by a qualified technician. Troubleshooting Check this information for a possible solution before calling for assistance. General troubleshooting • Every Rocketboost network must contain only one hub device, which helps other Rocketboost devices join the network. • You can turn any Rocketboost sender or sender/receiver into a hub by using the HUB STATUS or HUB ENABLE switch on the back of the device. The network can only have one hub. • The hub device must have power for the audio network to operate. The hub can be in standby (power-saving mode), but must remain plugged in. • The existing hub device will be the device with the green power indicator. • The unobstructed operating range of a Rocketboost network is 150 feet (45 meters). RF-RBREC 23