Rocketfish RF-RBREC User Manual (English) - Page 25

Specifications Audio input - wireless Audio output Transmission delay Power supply Power consumption Stereo, 16-bit, 48KHz, uncompressed Wireless audio system performance Signal-to-Noise Ratio: 94dB (96dB in HD mode) Total harmonic distortion: 1% High efficiency. Class D, speaker level Supports 4 to 8 ohm speakers Audio output power: 2 × 42 W (RMS) into 4 ohms 15 to 20 ms AC 120V~60 Hz (RF-RBREC) AC 220-240V~50 Hz (RF-RBREC-05A) 30 W Legal notices FCC and IC Information: This device complies with Part 15 of the FCC Rules and RSS-210 of the IC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: RF-RBREC 25