Ryobi A25RT03 Operation Manual - Page 14
Attaching The Featherboard, Inserting The Starting Pin, Installing The Miter Gauge
View all Ryobi A25RT03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ASSEMBLY Press throat plate into insert plate slot until it snaps into place. To remove, push throat plate out from the bottom of the insert plate. 3 2 1 0 ATTACHING THE FEATHERBInchO1 ARD See Figure 15. n Unplug the router table and/or the router. Insert the featherboard bolts through the slots in the fence assembly. Slide the featherboard over the featherboard bolts. Install the fence lock knobs and carriage bolt washers over the carriage bolts. Tighten the fence lock knobs. INSERTING THE STARTING PIN See Figure 16. Remove the starting pin from the blister pack. Place the starting pin on the router table and use it as a pivot point when cutting small, odd-shaped pieces. 3 2 NOTE: It is not necessary to use the fence0 wh1 en you are using the starting pin, but the bit guard1 should be used to cover the cutter. Additionally, only uIsnechpiloted cutters when using the starting pin. n Unplug the router table and/or the router. n Place the starting pin into the hole to the right of the router table throat opening. n Push the pin in to secure. INSTALLING THE MITER GAUGE See Figure 17. n Unplug the router table and/or the router. With the router table right side up, and the front edge closest to you, place the miter gauge bar in the slot near the front of the table with the pointer on the right. FENCE LOCK KNOB MITER GAUGE BAR 3 2 1 0 1 Inch SLOT FEATHERBOARD BOLT 3 2 1 0 1 Inch FEATHERBOARD CARRIAGE BOLT WASHER Fig. 15 STARTING PIN DIFREEECDTION STARTING PIN HOLES Fig. 16 1 Inch MITER GAUGE POINTER 3 2 1 0 1 Inch 14 - English SLOT Fig. 17