Ryobi A25RT03 Operation Manual - Page 15
Attaching The Vacuum Hose, Clamping The Router Table To A Work, Bench, Mounting The Router Table
View all Ryobi A25RT03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ASSEMBLY ATTACHING THE VACUUM HOSE See Figure 18. The vacuum port molded into the fence will accept either a 1-1/4 in. or 2-1/2 in. vacuum attachment. CLAMPING THE ROUTER TABLE TO A WORK BENCH See Figure 19. n Unplug the router table and/or the router. Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top. Using a clamp, insert the top front of clamp through the opening in the router table leg. Tighten clamp securely. MOUNTING THE ROUTER TABLE TO A WORK BENCH See Figure 20. n Unplug the router table and/or the router. Place the router table right side up on a sturdy work surface; e.g., leg stand, workbench, counter top. Mark the holes with a pencil. Remove the router table. Drill four holes through the work surface. Place the router table back on the work surface, aligning the holes in the table legs with the holes in the work surface. NOTE: Position the router table surface at approximately hip height. Insert four bolts (not included, 1/4-20 recommended) and tighten securely with flat washers, lock washers, and hex nuts (not included). 1 Inch FEDEIDRECTION VACUUM PORT 3 2 1 0 1 Inch VACUUM HOSE Fig. 18 inch 3 2 1 0 1 Inch WORK TABLE 3 2 1 0 1 Inch CLAMP Fig. 19 BOLTS inch 3 2 1 0 1 Inch FLAT WASHER HEX NUT 15 - English LOCK WASHER WORK TABLE Fig. 20