Ryobi P4360A User Manual - Page 12
Operation
View all Ryobi P4360A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION Make a shallow first cut (1/4 of limb diameter) on the underside of the limb close to the main limb or trunk. Make a second cut from the top side of the limb outboard from the first cut. Make a final cut close to trunk. �NOTE: For second and final cuts (from top of limb or branch), hold front cutting guide against the limb being cut. This will help steady the limb and make it easier to cut. Allow chain to cut for you; exert only light downward pressure. If you force the cut, damage to the bar, chain, or engine or motor can result. Release the trigger as soon as the cut is completed, allowing the engine or motor to stop. If you run the pruner at full speed without a cutting load, unnecessary wear or damage can occur to the chain, bar, and engine or motor. Failure to follow proper cutting procedures will result in the bar and chain binding and becoming pinched or trapped in the limb. If this should happen: Stop the engine or motor. Remove the spark plug wire or disconnect from the power supply. Loosen the knob on the coupler. Depress the button on the shaft; twist and pull the shafts to separate the pruner from the power head. If the limb can be reached from the ground, lift the limb while holding the attachment. This should release the "pinch" and free the pruner. If the pruner is still trapped, call a professional for assistance. Check the chain tension frequently when operating the unit. Refer to Chain Tension in the Maintenance section of this manual. LIMBING AND PRUNING See Figures 7 - 8. This unit is designed for trimming small branches and limbs up to 6 in. in diameter. For best results, observe the following precautions: Plan the cut carefully. Be aware of the direction in which the branch will fall. Branches may fall in unexpected directions. Do not stand directly under the branch being cut. The most typical cutting application is to position the unit at an angle of 60° or less, depending on the specific situation. As the angle of the pruner shaft to ground increases, the difficulty of making the first cut (from the underside of limb) increases. � Remove long branches in several stages. � Cut lower branches first to allow the top branches more room to fall. Work slowly, keeping both hands on the tool with a firm grip. Maintain secure footing and balance. Keep the tree between you and the chain while limbing. Cut from side of tree opposite branch you are cutting. � Do not cut from a ladder, rooftop, or other unstable support; this is extremely dangerous. Hire a professional for complex cutting situations. Do not make the flush cut next to the main limb or trunk until you have cut off the limb further out to reduce the weight. Following proper cutting procedures will prevent stripping the bark from the main member. Do not use the pruner for felling or bucking. To prevent electrocution, do not operate within 50 ft. of overhead electrical lines. Keep bystanders at least 50 ft. away. POSITION FOR STARTING See Figure 9. Lay the pruner on the ground and ensure that no objects or obstructions are in the immediate vicinity. Make sure nothing can come in contact with the bar and chain, including dirt on the ground. 8 - English