Ryobi P610 English Manual - Page 11
Charging A Hot Battery Pack, To Install Battery Pack, Caution, To Remove Battery Pack
View all Ryobi P610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPERATION CHARGING A HOT BATTERY PACK When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Authorized Service Center for checking or replacing. NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING A COOL BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check. TO INSTALL BATTERY PACK See Figure 5. Place the lock-off button in the center position to lock the switch. Place the battery pack in the tool. Align raised rib on battery pack with the groove inside the tool. Slide the battery pack into the tool until the latches on each side of the battery pack snap into place and battery pack is secured in the tool before beginning operation. CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the battery port of the planer and latches into place properly. Improper installation of the battery pack can cause damage to internal components. TO REMOVE BATTERY PACK See Figure 5. Place the lock-off button in the center position to lock the switch. Locate latches on side of battery pack and depress to release battery pack from the tool. The battery pack will automatically disconnect when buttons are depressed. Remove the battery pack from the tool. BATTERY PACK SHOWN IN CHARGER P110 CHARGER P100 BATTERY PACK YELLOW LED RED LED GREEN LED Fig. 4 BATTERY PACK LATCH Fig. 5 11