Ryobi RY31EP26 Operation Manual

DANGER:

To reduce the risk of injury, the user must read and understand this operator’s manual as

well as the operator’s manual for their pressure washer before using this product. Failure to

follow all warnings and precautions may result in death, serious personal injury, or property

damage.

IMPORTANT SAFETY WARNINGS

n

Keep at least 50 feet away from power lines. Do not touch or aim spray at electrical wiring

of any kind.

n

Do not extend or retract the telescoping pole or change nozzles or accessories while spray-

ing or while the wand is under pressure. Turn off the pressure washer, shut off the water

supply, point the nozzle in a safe direction, and pull the trigger to release water pressure

before making any changes.

n

Do not use the telescoping pole while on a ladder or scaffolding.

n

When using the telescoping pole at any position less than fully extended, make sure the

high pressure hose is located so that it will not be stepped on, tripped over, or otherwise

subjected to damage or stress. Keep the hose clear of the working area.

n

Do not exceed the maximum rated pressure, volume, or temperature listed in the product

specifications.

n

Do not remove or alter any warning labels included on the telescoping pole.

n

Before beginning operation, make certain the area you plan to work in is clear of obstruc-

tions or hazards.

n

Maintain proper balance and control of telescoping pole at all times.

n

To minimize the risk of kickback, grip the telescoping pole firmly with both hands. A firm grip

together with a stiff arm will help you maintain control of the telescoping pole if kickback

occurs.

PRODUCT SPECIFICATIONS

Connections

...........................

M22 Inlet, 1/4 in. Quick Connect Tip, Threaded Accessory Port

Adaptor

....................................................................

Female M22 x 3/8 in. Male Quick Connect

Length

......................................................................................................

5 ft. extends to 16 ft.

Maximum Pressure

..............................................................................................

up to 4200 psi

Maximum Water Flow

......................................................................................................

8 GPM

Maximum Water Temperature

..........................................................................................

140°F

ASSEMBLING THE TELESCOPING POLE AND BRUSH ACCESSORY

See Figures 1 - 3.

To assemble the telescoping pole:

NOTE:

For easier assembly, lay each pole section out on the ground before beginning. Take

care to avoid kinking the hose during assembly.

n

Open the lock levers on each section of the telescoping pole.

n

Place the center sections of the telescoping pole into the opening on the trigger handle sec-

tion, starting with the largest diameter piece and ending with the smallest diameter piece.

Close the lock lever on each section once installed.

OPERATOR’S MANUAL

Telescoping Pole

RY31EP26

Fig. 1

LOCK

LEVERS

LOCK

LEVERS

TRIGGER

HANDLE

POLE

SECTION