Ryobi RY31EP26 Operation Manual - Page 2

n Feed the hose on the brush accessory mount section down through the middle of the assembled pole and trigger handle sections so that it exits from the base of the trigger handle as shown in fig. 2. n Remove the U-clip from the plastic bag attached to the trigger handle. n Insert the hose fitting into the water outlet and install the U-clip to secure the hose in place. Make sure the U-clip is fully seated. NOTE: If necessary, use a hammer to lightly tap the U-clip to ensure it is fully seated. To install the brush a­ ccessory: n Make sure the lock nut is fully installed on the threaded end of the brush accessory mount. n Open the lock lever on the brush accessory mount, slide it away from the trigger handle as far as possible, then close the lock lever to secure as shown in fig. 3. n Align the hole on the brush with the threaded end of the brush accessory mount and rotate the brush clockwise to install. Continue to turn the brush until it is fully installed and at the desired angle. n Turn the lock nut counterclockwise until it stops to secure the brush in place. NOTE: Other accessories may be commercially available that can be used with this telescoping pole by fitting on either the locking tab or the threaded end. Follow all manufacturer's instructions for the accessory being installed to assemble and use. The lock nut features a flat side and a tapered side. If you are using an accessory other than the brush provided, make sure to orient the lock nut to best fit the accessory you are using. NOTE: If you plan to use the extension pole while the brush is not installed, open the lock lever on the brush accessory mount, slide it down as far as possible toward the trigger handle, then close the lock lever to secure. This will protect the threads on the brush accessory mount during operation. CONNECTING THE SHOULDER STRAP See Figure 4. The telescoping pole comes with an adjustable shoulder strap to ensure user comfort and ease of operation. The shoulder strap should be installed and adjusted to a comfortable position before operating the telescoping pole. To install: n Place the shoulder strap over your shoulder. n Clip the buckle of the shoulder strap onto the clip bracket as shown. To adjust: n To change the position of the clip bracket, loosen the knob, slide the bracket up or down the pole as desired, then retighten the knob securely. n To tighten the shoulder strap, pull down on the loose end of the strap. BRUSH ACCESSORY MOUNT WATER OUTLET HOSE LOCKING TAB LOCK NUT THREADED END BRUSH ACCESSORY SHOULDER STRAP BUCKLE CLIP BRACKET KNOB 2 - English U-CLIP HOSE Fig. 2 EXTEND BRUSH ACCESSORY MOUNT Fig. 3 TELESCOPING POLE Fig. 4