Ryobi RY40530 Operation Manual 2 - Page 23
Bar and Chain Combinations
View all Ryobi RY40530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
CHAIN TENSIONING SCREW MAINTENANCE BAR MOUNTING NUTS CUTTERS CHAIN ROTATION MOUNTING SURFACE Fig. 24 CHAIN BAR CHAIN COVER CHAIN DRIVE LINKS Fig. 26 BAR MOUNTING NUTS Fig. 25 NOTE: When replacing the guide bar and chain, always use the specified bar and chain listed in the Bar and Chain Combinations section later in this manual. Remove the battery pack before you do any work on the chain saw. n Remove the bar mounting nuts using the combination wrench provided. n Remove the chain cover. n Remove the bar and chain from the mounting surface. n Remove the old chain from the bar. n Lay out the new saw chain in a loop and straighten any kinks. The cutters should face in the direction of chain rotation. If they face backwards, turn the loop over. n Place the chain drive links into the bar groove as shown. NOTE: Make certain of direction of chain. CHAIN DRIVE LINKS BAR GROOVE BAR STUDS Fig. 27 CHAIN COVER CHAIN TENSION PIN HOLE ADJUSTING PIN BAR MOUNTING NUTS Fig. 28 23 - English