Samsung HMX R10 User Manual (ENGLISH) - Page 8
National Electrical Code, ANSI/NFPA No., OUTDOOR ANTENNA GROUNDING - battery
UPC - 036725302402
View all Samsung HMX R10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
important safety instructions 15. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. 16. VENTILATION: Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the CAMCORDER and to protect it from overheating. These openings must not be blocked or covered. Never place your CAMCORDER on a bed, sofa, rug, or other similar surface: on or near a radiator or heat register. This CAMCORDER should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. 20. OUTDOOR ANTENNA GROUNDING: CAMCORDER, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the leadin wire and supporting structure, grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding to conductors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode. See figure below. 17. POWER SOURCES: The CAMCORDER should be operated only from the type of power source indicated on GROUND CLAMP ANTENNA LEAD IN WIRE the label. If you are not sure of the type of power supply at your home, consult your appliance dealer or local power company. A CAMCORDER is intended to be operated from battery power, or other sources, refer ELECTRIC SERVICE EQUIPMENT ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H) NEC NATIONAL ELECTRICAL CODE to the operating instructions. 21. LIGHTNING: 18. GROUNDING OR POLARIZATION: For added protection of this CAMCORDER This CAMCORDER may be equipped with during a lightning storm or when it is left either a polarized 2-wire AC line plug (a unattended and unused for long periods plug having one blade wider than the other) of time, unplug it from the wall outlet or a 3-wire grounding type plug, a plug and disconnect the antenna or cable having a third (grounding) pin. If you are system. This will prevent damage to unable to insert the plug fully into the outlet, the CAMCORDER due to lightning and try reversing the plug. If the plug still fails to powerline surges. fit, contact your electrician to replace your outlet. Do not defeat the safety purpose of 22. POWER LINES: the polarized plug. An outside antenna system should not be 19. POWER-CORD PROTECTION: Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords or plugs, convenient receptacles, and the ii point where they exit from the unit. located in the vicinity of overhead power lines or other electric light or power circuits where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.