Samsung HT-C7530W User Manual (user Manual) (ver.2.0) (English) - Page 21

English, Fully insert the Stand Bracket into the speaker's clasp to stand

Get Samsung HT-C7530W PDF manuals and user guides
UPC - 036725617339
View all Samsung HT-C7530W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

02 Connections 5. Insert and tighten three large screws (5x15, For connecting Stand Pole & Stand Base) into the three holes on the bottom 5 side of the stand-base as shown in the illustration. ! CAUTION  When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm) 6. Connect the speaker wire to the speaker jack. 6 7. Fully insert the Stand Bracket into the speaker's clasp to stand speaker. 7 8. Insert and tighten two small screws (4x20, For connecting Stand Bracket & Speaker) into the two holes to connect them. 8 9. This is the appearance after the speaker is installed. 9 Follow this steps to install other speaker. 21 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
English
21
02
Connections
5
Insert and tighten three large screws (5x15, For connecting
Stand Pole & Stand Base) into the three holes on the bottom
side of the stand-base as shown in the illustration.
CAUTION
When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
5.
!
6
Connect the speaker wire to the speaker jack.
6.
7
Fully insert the Stand Bracket into the speaker's clasp to stand
speaker.
7.
8
Insert and tighten two small screws (4x20, For connecting Stand
Bracket & Speaker) into the two holes to connect them.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
8.
9.
9