Samsung HT-C7530W User Manual (user Manual) (ver.2.0) (English) - Page 23
Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit
UPC - 036725617339
View all Samsung HT-C7530W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
02 Connections ✎ NOTE Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, some sound interruption may be heard due to interference. If you use a device such as a microwave oven, wireless LAN Card or any other device that uses the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due to interference. The transmission distance from the product to the wireless receiver module is about 33 feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal. If the product doesn't make wireless connection, the system needs ID Setting between the product and wireless receiver module. With the product turned off, press the remote control's number buttons "0"J"1"J"3"J"5" and turn on the product. With the wireless receiver module turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds. ! CAUTION The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture. For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions. If no sound is heard from the wireless surround speakers, switch the mode to DVD 5.1 channel or Dolby Pro Logic II. In 2-CH mode, no sound will be heard from the wireless surround speakers. Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit If you attach the included Toroidal ferrite core to the power cord of the man unit, it will help to prevent RF interference from radio signals. 1. Pull the fixing tab of the Toroidal ferrite core to open it. 2. Make a loop twice in the main unit power cord. 3. Attach the Toroidal ferrite core to the main unit power cord as shown below, and then press it until it clicks. iPod 23 English