Samsung HW-D650S User Manual (user Manual) (ver.1.0) (English) - Page 58

Other Information Symptom Check Can't select Dolby Pro • Is the input signal selected Logic llx mode. properly? Can't select NEO:6 mode. There is no sound when playing a DTS encoded DVD. • Is the input signal selected properly? • Is Digital input selected? Remedy • Only 2 channel signal can select Dolby Pro Logic IIx mode. (ex:Dolby Digital, PCM, 2 channel analog input signal.) • Use PCM and Analog input signal. • Check whether the DVD player is properly connected and refer to page 30 to select the digital input. Product Protection Function Heat protection • The protection function will come on if the main unit or power transformer overheats. " " will appear in the display . This function will come on : - If speaker terminal is shorted - If speaker cable is shorted If there is no problem when you turn the unit on again after turning it off, PROTECTION mark will disappear on the display and the unit will work properly. Error No. E02 NO MIC E03 NOISY E04 MIC LEVL E05 NO FRONT E07 LEVL OVR E08 DIST OVR E13 TIME OVR E14 CODE ERR Auto Calibration Error List Auto Calibration Error Message on OSD Connect the calibration microphone. Keep quiet during the measurement. The speaker are too close to the microphone. Install all speakers and the calibration microphone at the proper location. Connect the front speaker correctly. Install all speakers and the calibration microphone at the proper location. Some speakers are too far from calibration microphone. Install all speakers and the calibration microphone at the proper location. Unplug and re-plug the power cable. Then, perfrom the measurement again. Unplug and re-plug the power cable. Then, perfrom the measurement again. 58 English HW-D600_D650S_XAA_0616.indd 58 2011-06-16 10:28:08