Samsung ML-1440 Service Manual - Page 50
Satins on Back of Blank Print out 1, 2-16 Blank Print out 2
View all Samsung ML-1440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Troubleshooting 4-2-14 Satins on Back of Page • Description The back of the page is stained at 56.1 mm intervals. DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr 70 mm Check and Cause 1. Transfer roller is contaminated. 2. Pressure roller is contaminated. 4-2-15 Blank Page Print out (1) Solution 1. Perform the OPC Cleaning Mode Print 2 or 3 times. Run Self-Test to remove the contamination of the transfer roller. 2. Replace the transfer roller if contaminated severely. 3. Disassemble the fuser and clean the H/R(Heat Roller) and P/R(Pressure roller). And check the area between H/R and Thermistor. If contaminated, clean the area not to be deformed. • Description Blank page is printed. Digital Printer Digital Printer Digital Printer Digital Printer Digital Printer Check and Cause Bad ground contacts in OPC and/or developer. Solution Remove contamination of the terminals of the developer and the unit. 4-2-16 Blank Page Print out (2) • Description 1. Blank page is printed. 2. One or several blank pages are printed. 3. When the printer turns on, several blank pages print. DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr DDiiggiittaall PPrriinntteerr Check and Cause 1. Bad ground contacts in OPC and/or developer. 2. Abnormal solenoid. Solution 1. Remove contamination of the terminals of the developer. 2. Perform the engine self test using DCU to check if the Solenoid is normal.(refer to code 06) 3. If not solved by the above directions 1-2, Replace the engine board. 4. Turn the power off, delete the data of PC and try printing again. 4-12 Samsung Electronics