Samsung ML-1865W User Manual (user Manual) (ver.1.01) (English) - Page 58

Paper feeding problems Condition Suggested solutions Paper jams during printing. Clear the paper jam. (See "Clearing paper jams" on page 55.) Paper sticks together. • Check the maximum paper capacity of the tray. (See "Print media specifications" on page 67.) • Make sure that you are using the correct type of paper. (See "Print media specifications" on page 67.) • Remove paper from the tray and flex or fan the paper. • Humid conditions may cause some paper to stick together, replace with a new stack. Multiple sheets of paper do not feed. Different types of paper may be stacked in the tray. Load paper of only one type, size, and weight. Paper does not feed • Remove any obstructions from inside the into the machine. machine. • Paper has not been loaded correctly. Remove paper from the tray and reload it correctly. • There is too much paper in the tray. Remove excess paper from the tray. • The paper is too thick. Use only paper that meets the specifications required by the machine. (See "Print media specifications" on page 67.) The paper keeps jamming. • There is too much paper in the tray. Remove excess paper from the tray. If you are printing on special materials, use the manual feeder. • An incorrect type of paper is being used. Use only paper that meets the specifications required by the machine. (See "Print media specifications" on page 67.) • There may be debris inside the machine. Open the top cover and remove any debris. Transparencies stick Use only transparencies specifically designed together in the paper for laser printers. Remove each transparency as exit. it exits from the machine. Envelopes skew or Ensure that the paper guides are against both fail to feed correctly. sides of the envelopes. Printing problems Condition The machine does not print. Possible cause Suggested solutions The machine is not receiving power. Check the power cord connections. The machine is not selected as the default machine. Select your machine as your default machine in your Windows. Check the machine for the following: • The top cover is not closed. Close the top cover. • Paper is jammed. Clear the paper jam. (See "Clearing paper jams" on page 55.) • No paper is loaded. Load paper. (See "Loading paper in the tray" on page 37.) • The toner cartridge is not installed. Install the toner cartridge. If a system error occurs, contact a service representative. The connection cable between the computer and the machine is not connected properly. Disconnect the machine cable and reconnect it. The connection cable between the computer and the machine is defective. If possible, attach the cable to another computer that is working properly and print a job. You can also try using a different machine cable. The port setting is incorrect. Check the Windows printer settings to make sure that the print job is sent to the correct port. If the computer has more than one port, make sure that the machine is attached to the correct one. The machine may be configured incorrectly. Check the Printing Preferences to ensure that all of the print settings are correct. (See "Opening printing preferences" on page 42.) The printer driver may be incorrectly installed. Repair the machine software (See "Installing USB connected machine's driver" on page 23). The machine is malfunctioning. • Check the LEDs on the control panel to see if the machine is indicating a system error. If the error cannot be cleared, contact a service representative. • Checking an error message is also possible from the Smart Panel on your computer. Troubleshooting_ 58